The nominal wireless range of the 5869 wireless panic switch is 200' back to the wireless security system.
#RESIDEO PANIC BUTTON INSTALL#
You should not install the 5869 under metal counters or desks as it will reduce the panic button's wireless range. Another tamper can be triggered if the 5869 is forcibly removed from its mounting surface.
One tamper will be triggered if the cover of the holdup switch is removed. The Honeywell 5869 has (2) separate tamper switches. The panic switch is then ready to trip another panic alarm. Once the holdup switch has been activated, you must use the included reset key to restore the 5869. However, you may program the holdup switch with whichever response type suits your application. Typically the 5869 wireless transmitter is programmed as a 24 hour silent zone type so that the central monitoring station can send the police immediately without the intruder being tipped off with a local alarm. With the 5869 panic button mounted under a counter or desk, the employee simply sticks his or her finger in the hole and pulls forward to activate a panic alarm even when your security system is disarmed. Protect your employees by providing them with a discreet way to signal a panic alarm. The 5869 works great as a holdup button for underneath a desk or cash register. This procedure is available for 24 hours after enrollment with a panel and the device remains powered (battery installed).The Honeywell 5869 is a wireless commercial panic switch. The PROSiXPANIC device self-deletes from the panel it was enrolled in. When successful, the LED comes back on flashing. If the device is enrolled in a panel different than the intended panel, and you are unable to delete it from the unintended panel, reset the device to factory default setting: Press and hold both buttons for 15 seconds. When removed from a system, the PROSiXPANIC will revert to factory default settings. Please note, the PROSiXPANIC cannot be used with another system until it is removed from the current controller. Once enrolled, verify adequate signal strength by conducting a sensor test. When done, the LED lights solid green for 3 seconds to confirm enrollment.
#RESIDEO PANIC BUTTON MAC#
The LED flashes green during enrollment and the device sends its unique MAC ID (Serial Number) and Services information to the controller. To enroll the PROSiXPANIC, set the controller in Programming Mode, press and hold the button for about 3 seconds until the LED flashes green to activate the enrollment process.
The PROSiXPANIC has the following LED indications Green Flashing lights when unit is transmitting, Red Flashing lights indicate low battery (lights during button press).
To clear memory of alarm, select Disarm and enter a user code. To clear the alarm at the control, enter a user code. The PROSiXPANIC wireless sensor is simple to activate, just press and hold both buttons briefly until the LED flashes. The PROSiXPANIC 2-button wireless sensor is compatible with the ProSeries PROA7, ProSeries PROA7C, ProSeries Canada PROA7CN, ProSeries PROA7PLUS, ProSeries PROA7PLUSC or ProSeries Canada PROA7PLUSCN all-in-one wireless touchscreen control panels. The Resideo Honeywell Home PROSiXPANIC is a wireless bi-directional panic sensor that is intended for use with control panels that support PROSiX-Series devices. ProSeries PROSiXPANIC Product Description:
0 kommentar(er)
